Pressure Reducing Valve Replacement in Ogden
A pressure reducing valve steps municipal supply pressure down to something a house can live with. When it fails, pressure either climbs until fittings and appliances start failing, or collapses so nothing works properly.
What to do right now
Do these first. None of them need tools or plumbing knowledge, and they limit what this ends up costing you.
- Note whether pressure is high or lowBoth are PRV symptoms and they point in opposite directions. Banging pipes, dripping relief valves and appliance failures suggest high. Weak flow everywhere suggests low.
- Check it is not just one fixtureA single weak tap is an aerator or a supply valve. Every fixture in the house behaving the same way points at the PRV or the supply.
Does this need a plumber tonight?
- A relief valve on the water heater discharging repeatedly
- Pipes banging hard enough to move
- Multiple fittings or appliances failing in a short period
- Pressure that is merely higher or lower than you would like
- One weak fixture with the rest normal
- A PRV you suspect but where nothing is failing
Why Ogden homes need them
Municipal supply in parts of Weber and Davis County arrives at pressures well above what residential plumbing and appliances are designed for, particularly where elevation differences across the distribution system are significant.
Domestic plumbing is generally happiest between about 50 and 70 psi. Supply arriving substantially above that shortens the life of everything it touches: fill valves, supply hoses, cartridges, dishwashers, washing machines and the water heater.
Properties on the bench in Pleasant View, North Ogden and Farmington are the ones where this shows up most often, because elevation and the distribution network interact.
- Water hammer, pipes banging when a tap closes
- The water heater relief valve discharging repeatedly
- Fill valves and supply hoses failing early
- Dripping taps that were recently serviced
- Appliance inlet valve failures
High pressure is a slow expensive problem
It rarely causes an emergency on its own. It causes a series of small failures over years that get treated individually while the actual cause sits untouched by the meter.
That is why it is worth measuring rather than guessing. A gauge on an outside tap costs very little and tells you in seconds whether the rest of your plumbing is being slowly destroyed.
If you have replaced several fill valves or supply hoses in a short period, measure the pressure before replacing another one.
What PRV work costs
[PLACEHOLDER: PRICING] Pending from the client.
Replacement is a straightforward scheduled job. What it prevents is a long series of small repairs, which is why it usually pays for itself.
Questions people ask about this
How do I know my pressure is too high?
Measure it. A screw on gauge for an outside tap is inexpensive and definitive. Anything much above 80 psi is doing damage.
My water heater relief valve keeps dripping.
That is frequently excessive supply pressure rather than a faulty relief valve, and replacing the relief valve without checking pressure treats the symptom.
Do all houses have a PRV?
No. Where supply pressure is naturally moderate, one may never have been fitted. Where it is high, one should be, and older houses sometimes have one that failed years ago unnoticed.
If that is not quite what you have
Not sure how urgent this is?
Describe what you can see and hear. We will tell you whether it needs someone tonight, and what to do in the meantime either way.
Or send it over
Four things and a photo.